Audio Related Controller

___Audio IC > Audio Related Controller___

___Part No.___ ______ (勾選方式)	___Features___	___Number of Channels___ ______ (勾選方式)	Supply Voltage (V) Min (Range)	Supply Voltage (V) Max (Range)	Supply Current (mA) Max (Range)	Output Voltage (Vrms) (Range)	THD (Range)	___Package___ ______ (勾選方式)
___UMPI06___	___Auto Identification Power Switch for Headphone Signal___ ______ ___* Supply voltage: 0.8V~3.6V___ ___* Automatic input signal identification and switching___ ___* Wide range of temperature___ ___* Small package and SC59-6 available___	___1___	0.8	3.6	0.4	-	-	___SOT-26___
___ULV1012___	___Pre-Amplified IC'S For High Gain 2-Wire Microphones___ ______ ___* Typical ULV1012-15, 2.2V Supply, RL=2.2kΩ, C=2.2μF___ ___,VIN=18mVPP, Unless Otherwise Specified___ ___* Supply Voltage: 2V ~ 5V___ ___* Supply Current: <180μA___ ___* Voltage Gain___ ___– ULV1012-07: 7.8dB___ ___– ULV1012-15: 15.6dB___ ___– ULV1012-20: 20.9dB___ ___– ULV1012-25: 23.8dB___	___1___	2	5	0.3	1.64	1	___SOT-26___
___U2429___	___Serial Data Control Dual Electronic Volume___ ______ ___* Built-in reference circuit___ ___* Control with serial data Volume 0 ~ -83dB (1dB/step), -∞___ ___(Independent control is allowed in each channel)___ ___* Low noise and low distortion VNO = 5μVrms (ATT = -∞)___ ___THD = 0.01% Typ. (V0 = 0.5Vrms)___	___2___	4.5	5.5	16	1.3	1	___SOP-8___ ___DIP-8___
___UM2750___	___4 Input/1 Output Stereo Audio Selector___ ______ ___* Dual Channel for Stereo Use___ ___* 4.7~13V Operating Voltage___ ___* 4 Input /1 Output Audio Selectors___ ___* Bipolar Technology___ ___* Low Output Noise: -110dBV typ.___ ___* Low Distortion: 0.005% typ.___	___2___	4.7	13	13	2.5	1	___SOP-16___
___UM2752___	___2 Input/1 Output Stereo Audio Selector___ ______ ___* Dual Channel for Stereo Use___ ___* 4.7~10V Operating Voltage___ ___* 2 Input /1 Output Audio Selectors___ ___* Bipolar Technology___ ___* Low Output Noise: -114dBV typ.___ ___* Low Distortion: 0.0009% typ.___	___2___	4.7	10	15	2.5	1	___TSSOP-14___
___ULV7084___	___Pre-Amplifier For Mems Mocrophone___ ______ ___* Operating voltage: 1.5V ~ 3.60V___ ___* Current consumption: 80μA typ.___ ___* Bias Voltage: +12.5V___ ___* Input equivalent noise: 3μVrms (-110dBV)___ ___* Frequency response: 20Hz~20kHz___ ___* Maximum output Voltage: 281mVrms (-11dBV) at THD < 5%___ ___* Gain: -3dB___ ___* Operating temperature: -40ºC~85ºC___	___1___	1.5	3.6	0.25	0.281	1	___SOT-23-5___
___U7313___	___Audio Processor IC___ ______ ___* Support I2C bus interface___ ___* 3 stereo inputs and selectable input gain___ ___* Volume control in 1.25dB/step___ ___* Loudness function___ ___* 4 independent speakers control___	___4___	6	10	11	2.5	0.3	___SOP-28___ ___DIP-28___
___UAP7313___	___Stereo Audio Processor For Car Audio___ ______ ___* 3 stereo inputs with gain selection, range from 0dB to +11.25dB in 3.75dB/step___ ___* Master volume from 0 dB to -78.75dB in 1.25dB/step___ ___* * Speaker attenuator for balance and fader, range from 0dB to -38.75dB in 1.25dB/step___ ___* Each channel output can be muted individually.___ ___* Bass and Treble control, range from -14dB to +14dB in 2dB/step___ ___* Wide operation range (VDD = 4V to 10V)___	___4___	4	10	40	2.5	0.01	___SOP-28___
___UPC1237___	___Protector IC For Stereo Power Amplifier___ ______ ___* Wide supply voltage range of 25V~60V.___ ___* Contain a relay driver. (Max. I6=80mA)___ ___* Latching / Automatic Reset function___ ___* Built-in output offset detection function. Both positive and___ ___negative output offset can be detected through pin2.___ ___* AC voltage can be detected.___ ___* External Time Delay Function___	___1___	25	60	8	-	-	___SIP-8___
___ALDR605___	___Capless 2Vrms Audio Line Driver With Adjustable Gain___ ______ ___* Integrated Charge pump generates negative supply rail___ ___* Provides flat frequency response from DC to 20kHz___ ___* Pop-Free under-voltage protection___ ___* Low noise and THD Typical THD+N = 0.001% (f =1kHz)___ ___* 2Vrms output voltage into 2.5kΩ load with 3.3V supply voltage___ ___* -40°C to +85°C operating temperature range___	___2___	3	3.6	14.5	2	1	___HMSOP-10___
___ALDR632___	___Direct 2-Vrms Audio Line Driver with Adjustable Gain___ ______ ___* Low THD+N<0.01% at 2Vrms Into 10kΩ___ ___* Stereo Direct Audio Line driver___ ___2Vrms Into 10KΩ With 3.3V Supply___ ___* Integrated Charge Pump Generates Negative Supply Rail___ ___* High SNR, >90dB___ ___* Ground-Referenced Outputs Eliminate DC-Blocking___ ___Capacitors___ ___* Differential Input and Single-Ended Output___ ___* Adjustable Gain by External Gain-Setting Resistors___ ___* Pop-Free Under-Voltage Protection___ ___* Short-Circuit Protection___ ___* Click- and Pop-Reduction Circuitry___ ___* Active Mute Control for Pop-Free Audio On/Off___ ___Control___	___2___	3	3.6	25	2	1	___TSSOP-14___
___ALDR6138___	___Direct Headphone Driver With Adjustable Gain___ ______ ___* Low THD+N<0.01% at 10mW Into 32Ω___ ___* Stereo Direct Headphone Amplifier driver___ ___40 mW Into 32Ω With 3.3-V Supply___ ___* Integrated charge pump Generates Negative Supply___ ___Rail___ ___* High SNR, >90dB___ ___* Ground-Referenced Outputs Eliminate___ ___DC-Blocking Capacitors___ ___* Differential Input and Single-Ended Output___ ___* Adjustable Gain by External Gain-Setting Resistors___ ___* Pop-Free Under-Voltage Protection___ ___* Configurable as a Second-Order Low-Pass Filter___ ___Ideal for PWM Audio Sources___ ___* Short-Circuit Protection___ ___* Click- and Pop-Reduction Circuitry___ ___* Active___	___2___	3	3.6	25	-	1	___TSSOP-14___
___ALDR8905___	___* Integrated Charge pump generates negative supply rail___ ___* Provides flat frequency response from DC to 20kHz___ ___* Pop-Free under-voltage protection___ ___* Low noise and THD___ ___Typical THD+N = 0.001% (f =1kHz)___ ___* 2VRMS output voltage into 2.5kΩ load with 3.3V supply voltage___ ___* 3VRMS output voltage into 2.5kΩ load with 5V supply voltage___	___1___	3	5.5	15.5	-	0.001	___HMSOP-10___
___PA309___	___* High voltage gain___ ___* High ESD voltage___ ___* Wide input signal___ ___* High gain linearity___ ___* Low input capacitance___ ___* Built-in capacitor 10pF for RF noise elimination___	___1___	1.4	5.5	0.3	-	0.29	___SOT-23-3___

This site uses cookies to collect the necessary user browsing behavior so that we can provide you with a better browsing experience. Browse this site, which means you agree with "online privacy declaration."