Other Interface

___INTERFACE > Other Interface___

___Part No.___ ______ (勾選方式)	___Features___	___Vcc(V)___	___Package___
___URCZ1284-XX___	___Parallel Port Single Termination With ±15KV ESD Protection___ ______ ___* Highly integrated termination___ ___* EMI noise filtering___ ___* RFI noise filtering___ ___* Withstand ±8 kV contact-discharge___	___5.0___	___QSOP-28___ ___SSOP-28___
___LS3718___	___20-Bit Serial To Parallel Converter___ ______ ___* 20-Bit serial in parallel out___ ___* Cascade connection___ ___* Operating voltage 5V±10%___ ___* Hysteresis input 0.5V typ___ ___* Output current 25mA___ ___* Operating frequency 5MHz or more___	___5.0___	___SOP-28___
___UTDA8024___	___IC CARD INTERFACE___ ______ ___* Three specifically protected half-duplex bidirectional buffered___ ___I/O lines to card contacts C4, C7 and C8___ ___* Automatic activation and deactivation sequences; initiated by___ ___software or by hardware in the event of a short-circuit, card___ ___take-off, overheating, VDD or VDDP drop-out___ ___* 26MHz integrated crystal oscillator___ ___* DC/DC converter for VCC generation separately powered from a___ ___5 V ± 20% supply (VDDP and PGND)___ ___* 3V or 5V ± 5% regulated card supply voltage (VCC) with___ ___appropriate decoupling has the following capabilities:___ ___- ICC<80mA at VDDP=4~6.5V___ ___- Handles current spikes of 40nAs up to 20MHz___ ___- Controls rise and fall times___ ___- Filtered overload detection at approximately 120mA___ ___* Built-in debounce on card presence contacts___ ___* Supply supervisor for spike-killing during power-on and___ ___power-off and Power-on reset (threshold fixed internally___ ___or externally by a resistor bridge)___ ___* Thermal and short-circuit protection on all card contacts___ ___* Clock generation for cards up to 20MHz (divided by 1, 2, 4 or 8___ ___through CLKDIV1 and CLKDIV2 signals) with synchronous___ ___frequency changes___ ___* Non-inverted control of RST via pin RSTIN___ ___* ISO 7816, GSM11.11 and EMV (payment systems)___ ___Compatibility___ ___* Enhanced ESD protection on card side (>6kV)___ ___* One multiplexed status signal OFF___	___3.3___	___TSSOP-28___
___UDS90LV011___	___3V LVDS SINGLE HIGH SPEED___ ___DIFFERENTIAL DRIVER___ ______ ___* >400Mbps (200MHz) Switching Rates___ ___* 700 ps (100 ps Typical) Maximum Differential Skew___ ___* 1.5 ns Maximum Propagation Delay___ ___* Single 3.3V Power Supply___ ___* ±400 mV Differential Signaling___ ___* Power Off Protection (Outputs in TRI-STATE)___ ___* Pinout Simplifies PCB Layout___ ___* Low Power Dissipation (23 mW @ 3.3V Typical)___ ___* Fabricated with Advanced CMOS Process Technology___	___3.3V___	___SOT-25___

This site uses cookies to collect the necessary user browsing behavior so that we can provide you with a better browsing experience. Browse this site, which means you agree with "online privacy declaration."